Operation; Turning The Ups On; Starting The Ups On Battery - Eaton Powerware 5125 User Manual

Chapter 4

Turning the UPS On

Starting the UPS on Battery

®
EATON Powerware

Operation

This section describes:
S
Turning the UPS on and off
S
Starting the UPS on battery
S
Operating modes
After the UPS is connected to a power outlet, it enters Standby mode.
To turn on the UPS, press and hold the On button until you hear the
UPS beep (approximately one second). The
solid and the load level indicators display the percentage of load being
applied to the UPS.
NOTE Before using this feature, the UPS must have been powered by utility power at least
once.
To turn on the UPS without using utility power, press and hold the
On button for at least four seconds. The UPS starts up in Battery mode
and supplies battery power to your equipment.
5125 Two-in-One UPS (2400/3000 VA) User's Guide
μ
indicator illuminates
S
164201383 Rev C www.power-
ware.com
33