Tower Setup - Eaton Powerware 5125 User Manual

INSTALLATION
NOTE The UPS and EBMs MUST be installed at the bottom of the rack. If placed in a rack
with existing equipment, the rack must be reconfigured to allow the UPS installation at the
bottom of the rack.
NOTE The EBMs must be installed below the UPS as shown in Figure 6.
4.
5.
6.

Tower Setup

The mounting brackets must be removed before positioning the
cabinets for a tower installation. Unscrew and remove the mounting
brackets on each side of all cabinets as shown in Figure 7.
22
EATON Powerware
ware.com
Slide the UPS and any optional EBMs into the rack.
Secure the cabinets to the rack according to the rail kit instructions.
Continue to "Installing the UPS" on page 27.
UPS
Optional
EBMs
Figure 6. Rack-Mount UPS with EBMs
Figure 7. Removing the Mounting Brackets
®
5125 Two-in-One UPS (2400/3000 VA) User's Guide
Mounting
Bracket
S
164201383 Rev C www.power-