Turning The Ups Off; Operating Modes - Eaton Powerware 5125 User Manual

OPERATION

Turning the UPS Off

NOTE Pressing the Off
down immediately.
To turn off the UPS:
1.
2.
3.

Operating Modes

The Powerware 5125 front panel indicates the UPS status through the
UPS indicators. Figure 21 shows the UPS front panel indicators and
controls.
Battery Mode Indicator
34
EATON Powerware
ware.com
button while the UPS is in Battery mode causes the UPS to shut
Prepare your equipment for shutdown.
Press and hold the Off
(approximately five seconds). The
UPS transfers to Standby mode (if utility power is available) and
removes power from your equipment.
Unplug the UPS.
If you do not unplug the UPS, it remains in Standby mode.
Normal Mode Indicator (solid green)
Standby Mode Indicator (flashing green)
Bypass Mode Indicator (solid red)
Figure 21. UPS Front Panel
®
5125 Two-in-One UPS (2400/3000 VA) User's Guide
button until the long beep ceases
μ
indicator begins to flash. The
On Button
Off Button
Alarm Reset Button
Load Level Indicators
S
164201383 Rev C www.power-
Indicator Legend
Unlit
Green
Red
Flashing