When To Replace Batteries - Eaton Powerware 5125 User Manual

NOTE To prevent power loss to your equipment, follow Step 4 closely.
4.
NOTE If the five load level indicators are flashing, the module may not be properly seated.
Remove and reinsert the module as described in Step 4.
5.
6.
7.
8.

When to Replace Batteries

When the
five seconds, the batteries may need replacing. Contact your service
representative to order new batteries.
®
EATON Powerware 5125 Two-in-One UPS (2400/3000 VA) User's Guide
While inserting the new electronics module, press and hold the
button for approximately five seconds or until the front panel
indicators illuminate individually.
Secure the electronics module to the UPS chassis with the screws
removed in Step 3.
Replace the UPS front cover.
Reconnect any cables removed in Step 1.
See "Recycling the Used Battery or UPS" on page 53 for proper
disposal.
indicator flashes and the audible alarm beeps once every
UPS MAINTENANCE
S
164201383 Rev C www.power-
ware.com
49