Pneumatic Retract Valve And Air Line Installation - Hangar 9 Jackal 50 ARF Assembly Manual


22. Use the radio system to move the carburetor to the
high-throttle position. If the servo binds, use the setting in
the radio to reduce the throw. If the carburetor is not fully
open, use the radio setting so the carburetor opens fully.
Hangar 9 Jackal 50 ARF
Pneumatic Retract valve and
Air Line Installation
Required Parts
Fuselage assembly
Air valve mount base Air valve mount
Air valve mount support (2) 2-56 x 2-inch pushrod
Nylon clevis Silicone clevis retainer
Plywood servo adapter plate
3mm x 8mm sheet metal screw (2)
Retract air valve kit
Required Tools and Adhesives
Phillips screwdriver: #1 Pin vise
Medium CA Pin vise
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
Zap-A-Dap-A-Goo similar or flexible adhesive

1. Locate the items necessary to install the air valve in
the fuselage. You will also need to have the fuselage, along
with the appropriate air control kit for your model.

2. Attach an appropriate colored line to the air tank. Use a
very small amount of flexible adhesive to secure the air tank
in the fuselage as shown.

3. Use a small amount of medium CA to glue the plywood
servo adapter plate in the fuselage. Make sure to center the
adapter plate over the existing retract servo opening in the
servo tray as shown.
51