10.5 Setpoints
Overview
You can use two separate local setpoints in the controller. The identifying register
addresses listed in Table 10-5 allow you to select which setpoint you want to use and to
enter a value in Engineering Units (whichever is selected at register address 00A1) for
that setpoint via communications.
Register Addresses
Make your selection using register address 00AD and enter the value for the setpoint
chosen using register address in Table 10-5.
Parameter
Description
Local Setpoint #1
Local Setpoint #2
Number of Local
Setpoints
Associated Parameters
Refer to Table 10-6 to display or change any of the parameters associated with the
setpoint.
Parameter
Setpoint Limits
Computer Setpoint
4/07
Modbus Read, Write and Override Parameters plus Exception Codes
Table 10-5 Setpoint Code Selections
Register
Address
Type
Hex
Decimal
0027
039
FP
0035
053
FP
00AD 173
INT
Table 10-6 Setpoint Associated Parameters
0007, 0008
007D
UDC2500 Universal Digital Controller Product Manual
Data
Access
R/W
Value within the setpoint
range limits
R/W
Value within the setpoint
range limits
R/W
00 = Local Setpoint #1
only
01 = 2nd Local Setpoint via
keyboard or
communications
Register Address
Hex
Data Range or
Enumerated Selection
Decimal
007, 008
125
193