Start Up Procedure For Operation; Setpoints - Honeywell UDC2800 Product Manual

Start Up Procedure for Operation

It is required to enter the initial password and a new password when
start up the controller for the first time. The initial password is 1234.
For more information of interface displays, see the section
of
Table 5-2: Procedure for Starting Up the Controller
Step Operation
1 Enter the
Local Setpoint

Setpoints

Introduction
You can configure the following setpoints for the UDC2800 Limit
Controller controller.
n
Change the Setpoint value
Table 5-3: Procedure for Changing the Local Setpoints
Step Operation
1 Select the
Setpoint
2 Change the
Value
displays.
Press
Lower Display key
Increment or
Decrement key
A Single Local Setpoint
Press Result
Lower Until you see:
Display key
Lower Display = SP
Increment To change the Local Setpoint to the value at which
key or you want the process maintained. The display
Decrement "blinks" if you attempt to enter setpoint values
key beyond the high and low limits.
The configured setpoint will be stored immediately.
Chapter 5 - Operating the Limit Controller
Result
Until the required "SP" and the Local
Setpoint Value are displayed.
To adjust the local setpoint to the value
at which you want the process variable
maintained.
Function
91