Viewing The Operating Parameters; Table 4-3 Lower Display Key Parameter Prompts - Honeywell UDC2500 Product Manual

Monitoring and Operating the Controller

4.5.2 Viewing the operating parameters

Press the
LOWER DISPLAY
4-3. The lower display will show only those parameters and their values that apply to
your specific model.

Table 4-3 Lower Display Key Parameter Prompts

Lower Display
OT XX.X
SP XXXX
2LXXXX
RSXXXX
2NXXXX
DEXXXX
PIDS X
HH.MM
RPXXXM
AX XXX
SnXXXX
BIXXXX
To BGn
NoTUNE
DoSLOW
DoFAST
POSXX.XX
94
key to scroll through the operating parameters listed in Table
OUTPUT—Output value is percent; for Three Position Step control, this is an
estimated motor position and shown with no decimal place.
LOCAL SETPOINT #1—Also current setpoint when using SP Ramp.
LOCAL SETPOINT #2
REMOTE SETPOINT
INPUT 2
DEVIATION—Maximum negative display is –999.9.
TUNING PARAMETER SELECTED SET—where X is either 1 or 2.
TIME REMAINING—Time that remains on timer in Hours.Minutes
ELAPSED TIME—Time that has elapsed on timer in Hours.Minutes.
SETPOINT RAMP TIME—Time remaining in the setpoint ramp in minutes.
AUXILIARY OUTPUT
SP RATE SETPOINT—Current setpoint for setpoint rate applications
BIAS—Displays the manual reset value for algorithm PD+MR.
TO BEGIN—Resets Setpoint Program back to beginning of the program.
Unit is currently not in Accutune process.
Accutune Slow tuning process is operating.
Accutune Fast tuning process is operating.
Three position
UDC2500 Universal Digital Controller Product Manual
Description
4/07