Ethernet Tcp/Ip; Overview - Honeywell UDC2500 Product Manual

Ethernet TCP/IP

11.1 Overview

Ethernet parameters can only be configured via the Process Instrument Explorer
software.
Ethernet IP Address is 10.0.0.2 as shipped from the Factory.
The MAC address is printed on the case label of each instrument.
When constructing a network, it is recommended that a Switch be used to connect UDCs
to a LAN rather than using a Hub. This is because a Switch passes only those messages
for IP addresses that are connected to the Switch while a Hub passes all message traffic.
Using a Switch thus improves the overall throughput of the traffic to and from the UDCs.
220
11 Ethernet TCP/IP
UDC2500 Universal Digital Controller Product Manual 4/07