Setpoints - Honeywell UDC2800 Product Manual

Setpoints

Introduction
You can configure the following setpoints for the UDC2800
controller.
n
n
n
n
n
See Control Set Up Group for more information.
See "Control Set Up Group" in UDC2800 Product Manual.
Change the Setpoint value
Table 5-5: Procedure for Changing the Local Setpoints
Step Operation
1 Select the
Setpoint
2 Change the
Value
A Single Local Setpoint
2 Local Setpoints
3 Local Setpoints
4 Local Setpoints
Up to 4 Local Setpoints and one Remote Setpoint
Press Result
Lower Until you see:
Display key
Lower Display = SP or 2SP or 3SP, or 4SP (Value)
Increment To change the Local Setpoint to the value at which
key or you want the process maintained. The display
Decrement "blinks" if you attempt to enter setpoint values
key beyond the high and low limits.
The configured setpoint will be stored immediately.
Chapter 5 - Monitoring and Operating the Controller
186