Setpoints; Table 5-10 Procedure For Selecting The Local Setpoint Source - Honeywell UDC 3300 Product Manual

5.7 Setpoints

Introduction
Selecting the local
setpoint source
160
You can configure the following setpoints for the UDC 3300 controller.
• A single local setpoint,
• Two local setpoints,
• One local setpoint and one remote setpoint,
• Three local setpoints,
• Two local setpoints and one remote setpoint.
To scroll through the setpoint type menu, press and hold in the
SETPOINT SELECT key. Release when the desired setpoint selection
is displayed.
ATTENTION
"KEY ERROR" will appear in the lower display if:
• You choose either local setpoint 2 or 3 or remote setpoint and your
choice has not been configured as the setpoint source.
• You attempt to change the setpoint while a setpoint ramp is enabled.
Setpoint ramp rate will apply, if enabled.
Use the procedure in Table 5-10 to select a local setpoint source.
Table 5-10 Procedure for Selecting the Local Setpoint Source
Step Operation
1 Enter Set Up
mode
2 Display Local
Setpoint Source
selections
3 Select the
desired source
4
Return to control
UDC 3300 Controller Product Manual
Press
until the displays read:
LOWER
Upper Display
DISPLAY
SET UP
Lower Display
CONTROL
for Loop 1
until the displays read:
FUNCTION
Upper Display
LOOP 1/2
Setpoint source selections
Lower Display
LSP'S
to select the desired setpoint source in the
or
upper display.
The controller will assume normal control.
LOWER
DISPLAY
Action
Upper Display
SET UP
Lower Display
CONTROL2
or for Loop 2
1 ONLY
TWO
THREE
4/00