Status Leds - Christie M-Series User Manual

Section 2: Installation and Setup

Status LEDs

Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2, Power, and
Status. The LEDs will display the colors as shown below:
Projector State
Hard Boot
Standby Mode
Warm-up (Powering ON from
standby)
Normal Operation
Cool-down
Error
Software Upgrade in progress
Lamp Regeneration in progress
2-26
LEDs
All All LEDs amber - means please wait
Lamp 1 & 2 Off - lamps are off
Power Amber - AC is present but projector is off or standby
Green - shutter is open
Shutter
Amber - shutter is closed
All LEDs cycle green from left to right
Lamp 1 & 2 Amber - lamp time has expired and lamp should be
replaced
Power Green - projector is powered up and operating nor-
mally
Green - shutter is open
Shutter
Amber - shutter is closed
All LEDs cycle amber from left to right
Amber - lamp time has expired and lamp should be
Lamp 1 & 2 replaced
Flashing Red - lamp has malfunctioned
Power Flashing Red - error has occurred. Details are dis-
played on the status display
All The pattern will alternate between:
Amber, Off, Amber, Off
and
Off, Amber, Off, Amber
Lamp 1 & 2 Flashing Green - the lamp is being switched off for its
regeneration period to extend lamp life (typically 15
minutes every 24 hours)
Power Green - on
or
Amber - standby
Shutter Green - shutter is open
LED State
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)