Input Switching & Pip Menu - Christie M-Series User Manual

Section 3: Operation
• ADVANCED DIAGNOSTICS:
Allows for the setting of advanced controls which may cause image disruption, including the possible loss of
the OSD menus. These disruptions are only temporary; pressing EXIT to exit the menu will restore the settings
and allow normal operation.
• OUTPUT PEAK DETECTOR:
Is an aid for setting up the input levels. It causes the data to be processed so that very bright and very dark
signals display as fully on or off, and everything in-between is set to mid level gray. The input levels should be
adjusted so that bright and dark objects in the image are just visible.
• OUTPUT LEVEL DETECTOR:
Is an aid for setting up the input levels. It causes the data to be processed so that all levels below a specified
value are set to black and all above (and including) it are set to white.
• INPUT LEVEL VALUE:
Specifies the value to be used by the level detector.
• LIGHT ENGINE TEST PATTERN:
One of 3 light engine test patterns may be displayed: black, white or grey scale.
Option Card Settings - Submenu
Allows adjustment of any settings specific to each option card that is currently installed in the projector.
Dynamic Iris - Submenu
Refer to Image Settings>Advanced Image Settings
3.9 Input Switching & PIP Menu
Use the Input Switching & PIP menu to enable
and define how you want to use PIP.
NOTE: To control the primary image, access all
picture controls through the Main menu. To
control the secondary (PIP) image, access
picture controls through the Input Switching &
Picture-in-Picture menu.
• MAIN INPUT:
From the list of active inputs, select one to be used
as the primary or main image.
• PIP INPUT:
From the list of active inputs, select one to be used as the secondary or PIP.
• SWAP MAIN AND PIP IMAGES:
Toggle the current PIP relationship so that the primary (main) image becomes secondary (PIP), and the
secondary image becomes primary. Swapping is available only when PIP is enabled. NOTE: There may be a
slight delay when swapping the Primary and Secondary images.
3-46
F 3-39 - I S
IGURE NPUT WITCHING
& PIP M
ENU
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)