2: Installation And Setup; Projector Quick Setup And Installation - Christie M-Series User Manual

2 Installation and Setup
This section explains how to install, connect and optimize the projector for delivery of superior image
quality. Illustrations are graphical representations only and are provided to enhance the understanding of
the written material.
2.1

Projector Quick Setup and Installation

The following instructions are for those preferring a quick setup. Refer to the remaining subsections for
detailed setup instructions.
cleaning.
STEP 1 - Installing a Projection Lens
The projection lens, shipped separately from the projector, must be installed prior to setting up the projector.
Retain the lens plug for projector transportation to protect the projector's optical components from
dust and debris.
IMPORTANT! The lens seals the projector, preventing contaminants from entering the interior of the
projector. Never operate a projector without a lens.
LENS INSTALLATION
1. Remove the rear lens cap from the lens. Keep the front lens cap on the lens to protect it during installation.
2. Rotate the lens clamp to the OPEN position, see
3. Remove and retain the 2 security screws from the lens mount, see
4. Align the lens interface plate with the lens mount. Align the lens electrical connector with the mating
connector on the lens mount. Fully insert the assembly straight into the lens mount opening without
turning. Press using your hand, see
that the lens IS NOT inserted at an angle. as this can cause damage.
5. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens
assembly in place.
6. For added stability such as motion applications, fasten the security screws, see
Location provided on the lens-mount, using the tool provided. NOTES: 1) Recommended for heaviest
lenses such as 0.73:1 and 1.2:1. 2) Security screws MUST be installed when hoisting the projector
overhead, or installing the projector in an overhead position.
7. Remove the front lens cap.
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
Always power down the projector and disconnect all power sources before servicing or
Refer to Safety Warnings and Guidelines in
Remove the lens plug from the lens opening in the projector before installing the lens.
Figure 2-3 - Lens
Section 5 Maintenance.
Figure 2-1 - Lens Installation.
Figure 2-2 - Security Screw Location.
Placement. NOTE: When installing the lens, ensure
Figure 2-2 - Security Screw
2-1