Christie M-Series User Manual page 34

Section 2: Installation and Setup
SETTING THE PROJECTOR'S IP ADDRESS, SUBNET MASK AND GATEWAY
System Parameters and Advanced Controls.
CHANGING THE PORT#:
projector be changed from its default of 3002. If so, enter a new port number in the Ethernet Settings menu or include
the new port#.
Separating Networks
By default, communications originating from one type of serial controller—RS232 vs. RS422 vs. Ethernet—stay on the
corresponding network path. A "Separate" setting indicates this separation for "Network Routing" in the
Communications menu, see
communicate only with the projector to which it is connected unless you change this setting to either "RS232 and
RS422 Joined" or "All Joined".
Communicating to all Ports
To relay all messages to all ports—RS232, RS422, and Ethernet—set the "Network Routing" option in the
Communications menu for each projector to "All Joined", see
are using a non-RS232 controller with the RS232 linking available between these projectors. For example, you may
want to use both an RS422-compatible controller and an Ethernet-connected PC for working with a network of
projectors linked via their RS232 in/out ports.
2-24
F 2-23 - E
IGURE
On some Ethernet networks, firewall restrictions may require that the port number of the
Section 4 Menu Tree. If you are using an RS422 controller, for example, it will
N S
THERNET ETWORK ETUP
: See
Section 4 Menu
Section 3.8 Configuration - Adjusting
Tree. This configuration is useful if you
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)