Christie M-Series User Manual page 87

• PIP ENABLE:
Short cut: Press PIP on the Remote if menu not
present.
Toggle between displaying two sources at once
(Main and PIP images) and the primary or main
source only. This checkbox turns the secondary
source on and off.
PIP Size & Position - Submenu
Most controls in the PIP Size and Position menu
adjust the PIP (secondary) image in the same fashion as their counterparts in the main Size and Position menu.
• POSITION PRESETS:
Set the location of the PIP (secondary) image in the display.
PIP Image Settings - Submenu
The controls adjust the PIP (secondary) image in the same fashion as their counter parts in the main Image
Settings menu. NOTE: Refer to
Settings.
• PIP BORDER WIDTH:
Enables the optional border around the PIP image. When enabled, a one pixel-wide border will surround the
PIP image. When disabled, no border will be displayed.
• PIP BORDER COLOR:
This control allows you to choose the color of the optional border around the picture-in-picture image. The
border can be disabled by setting the width to zero.
• FADE TIME:
Sets the amount of time (in seconds) it takes to fade between images on a source switch and fades in the PIP
image.
• FRAME LOCKING:
This option allows the projector to control the output frame timing based on the input signal. The Frame Lock
option forces (if possible) the output image to be phase locked to the input frames. When Frame Locked, the
output is always locked to the primary input, and never to the PIP image. Free Run sets the output to run at a
fixed frame rate frequency. The frequency is defined by Free Run Frequency. By default, the free run
frequency is 59.94Hz. NOTE: Seamless switching is only available when free run is selected. When switching
to a new input with frame locking enabled, the image will be black for the short period while the system locks
onto the new input.
• AUTO INPUT SEARCHING:
When enabled, the system will continually search for the next valid signal when no signal is present or when
loss of sync occurs on the current user selected input. In the case of multiple signals to choose from, the order
is based on slot, followed by inputs on that slot.
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
3.7 Image Settings Menu for details of Contrast to Advanced Image
Section 3: Operation
3-47