Christie M-Series User Manual page 39

Video Decoder Input Card
This card accepts and decodes standard definition (SD) video. This includes CVBS (composite video), S-
Video, and component sources. This card supports as many as 6 video signals, four of them on BNC
connectors and two on 4-pin mini-DIN connectors. Each mini-DIN connector accepts 1 S-Video signal. The
first BNC accepts composite video (only), while the remaining three BNC's can be grouped to allow one of the
following combinations:
• 3 CVBS sources on 4, 5 & 6
• 1 CVBS source, 1 S-Video source: Luma(Y) connected to 4(Sy) and Chroma(C) connected to 6(Sc)
• 1 YPbPr source: component signal on 4(Pr), 5(Y) & 6(Pb)
The video decoder input card has 8 LED indicators. The PWR LED indicates that the module is installed
properly, and has been successfully configured. The YPbPr LED indicates that a valid component signal has
been detected on inputs 4, 5, and 6 (Component input grouping must also be selected in the projector's menu -
see Section 3 Operation.
signal has been detected on that input.
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
The remaining LEDs are each associated with one of the inputs, and indicate a valid
Section 2: Installation and Setup
2-29