Labels And Marking - Christie M-Series User Manual

1 Introduction
Every effort has been made to ensure the information in this document is accurate and reliable; however,
due to constant research the information in this document is subject to change without notice.
USERS/OPERATORS: This manual is intended for trained users operating professional high-brightness
projection systems. Such users may also be trained to replace the lamp and air filter, but cannot install the
projector or perform any service functions on the M-Series projector.
SERVICE: Only CHRISTIE accredited technicians knowledgeable about all potential hazards associated
with high voltage, ultraviolet exposure and high temperatures generated by the lamp and associated
circuits are authorized to 1) assemble/install the projector and 2) perform service functions inside the
projector.
This manual contains the following sections:
• Section 1 Introduction
• Section 2 Installation and Setup
• Section 3 Operation
• Section 4 Menu Tree
• Section 5 Maintenance
• Section 6 Troubleshooting
• Section 7 Specifications
• Section Appendix A: GPIO
Disclaimer:
Every effort has been made to ensure the information in this document is accurate and reliable. However,
due to constant research, the information in this document is subject to change without notice. Christie Digital Systems
assumes no responsibility for omissions or inaccuracies. Updates to this document are published regularly, as required.
Please contact Christie Digital Systems for availability.
1.1

Labels and Marking

Observe and follow any warnings and instructions marked on the projector.
do not follow the advise in this section.
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
Symbols are used to alert situations where the user will become seriously injured if they
Warning symbols are used to alert situations where a user may be injured.
Caution symbols are used to convey information where equipment damage will occur.
1-1