Channel Setup Menu - Christie M-Series User Manual

If you used the source once before and changed a display parameter, such as contrast, V-Position, etc., then a
channel was automatically created and still exists in projector memory (see CHANNEL below). Using one of
the input or slot keys will automatically recall this channel—and all its setup parameters—and update the
display accordingly.
If more than one channel exists for the input, the image will be displayed according to the setup parameters for
the first channel with matching characteristics.
Creating a New Channel
To use a new source with the projector, a new channel must be created so that the projector will respond to an
input signal from that source. A new channel can be created automatically, or it can be copied from an existing
channel and then edited as necessary, refer to
When you select a direct input (S
searched for matching input and signal parameters – this only occurs if Auto Source is enabled on these
channels. If no match to the incoming input signal is found in currently defined channels, a new channel is
temporarily created based on factory-defined defaults for this type of signal. The channel number assigned is
the lowest available number from 01-99. NOTES: 1) An automatic channel will be discarded unless one or
more of its parameters are changed and will not appear in the channel list (see below). 2) If 2 channels have
the same distinguishing source characteristics except for the reversal of sync connectors (i.e., H-sync and V-
sync, are switched), they are still defined as distinct channels. 3) You cannot define a new channel without an
incoming signal.
USING A CHANNEL: You can normally select a channel at any time by pressing C
you want to hide a channel from appearing in this list, you must edit the channel refer to
channel can still be selected by entering its number as shown below.
NOTES: 1) The current channel is
highlighted in the channel list, or, if the
current channel is hidden, the first channel in
the list is highlighted. 2) Channels created
automatically do not appear in the channel
list unless a parameter for the channel has
been changed.
3.4

Channel Setup Menu

All available channels are listed in the Channel Setup menu, which describes how each channel can be
accessed and provides access for editing, copying and deleting channels.
Press M from the presentation level to display the Main menu. To display the Channel Setup menu, press
ENU
3, or move the highlight to the Channel Setup option and press E
(see sample below).
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
Figure 3-14
3, or S
1, S 2, S
LOT LOT LOT
and Figure 3-15.
4), any existing channels in the projector are
LOT
F 3-12 - U
IGURE SING A
. The Channel Setup menu will appear
NTER
Section 3: Operation
(see below). If
HANNEL
Figure 3-16. Such a
C
HANNEL
3-13