Christie M-Series User Manual page 73

• TURN OFF IMAGE AFTER (min):
This sets the activation interval (in minutes) for Auto Shutdown. If all activity (input signals, web or serial port
activity, key presses) is lost for this length of time, and Auto Shutdown is enabled, an Auto Shutdown cycle
will begin.
• ENTER STANDBY AFTER (min):
This sets the interval (in minutes) between starting Auto Shutdown and entering Standby mode. Once Auto
Shutdown has been entered, and all activity continues to be absent for this interval, the projector will
automatically enter power Standby mode.
• LAMP REGENERATION START TIME:
For 24/7 operation, the lamp regeneration cycle is required or lamp life will be reduced. This control allows
you to set the time of day (in 24 hour format) when the regeneration cycle will start. In Dual Lamp mode, the
cycle will be performed on each lamp separately. The second lamp will wait for the first lamp to come back on
before it begins the cycle. In single lamp mode, the projector will go into Standby mode for the regeneration
cycle. The regeneration cycle will run for 15 minutes for each lamp. The lamp(s) must run for a minimum of
24 hours or the regeneration cycle will be skipped.
• OVER-TEMP FAN ASSIST:
When enabled, this option will cause all fans to come on at full speed if any enabled thermal sensor has an
over-temperature fault. This may help to prevent an emergency shutdown if the extra cooling can bring the
temperature within limits before the shutdown occurs. The fan assist will cause increased noise levels due to
the simultaneous full speed operation of all the fans. Normal operation will resume when all over-temperature
conditions are removed or fan assist is turned off.
Date & Time - Submenu
The current year-month-day, hour-minute-second, and timezone. Changes here reset the projector's real-time
clock.
Menu Preferences - Submenu
Adjust the appearance, content and/or location of on-screen menus and messages.
• LARGE MENU FONT:
Enter a checkmark to enlarge menus and their text. To adjust Menu Location to accommodate the increased
menu area.
• MENU LOCATION:
Use the pull-down list to choose a pre-defined default or customized location for the display of all on-screen
menus.
To create a custom menu location:
1. Choose a preset that is closest to the desired location.
2. Adjust Horizontal Shift and Vertical Shift slide bars to move the menu to the desired location. NOTE:
Avoid locations too close to a corner or edge to prevent cropping of larger menus.
• HORIZONTAL SHIFT AND VERTICAL SHIFT:
Shift your menus as desired, creating a customized menu location.
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
Section 3: Operation
3-33