Adjusting The Image; Size And Position Menu - Christie M-Series User Manual

• NEXT CHANNEL:
Select this option to see or change Channel Edit settings for the next channel in the Channel Setup list.
3.5

Adjusting the Image

The most commonly used options for image adjustments are accessed through two menus: Size and Position
(M 1) and Image Settings (M
ENU
menus. You can change settings affecting the image from the current channel by working with the appropriate
slide bars, checkboxes and pull-down lists. E
the Main menu) and accept any changes you may have entered. Settings are saved with the current channel.
From your presentation, you can access any of the individual options in these menus by pressing M
followed by the appropriate two-digit number representing their location in the menu system. For example,
press M 23 to quickly access the "Gamma" option in the Image Settings menu.
ENU
NOTES: 1) For certain options, preference may be to use a "direct key" from presentation level to go
directly to a particular option without traveling through the menu system (available for certain display
parameters only). For example, press C
to return to your presentation. 2) To hide "direct" slide bars, disable the Display Slide bars checkbox in the
Menu Preferences menu. 3) To hide the entire menu system from view, turn off the on-screen display by
pressing OSD then the D
For a good and efficient first step in perfecting the image, press the auto setup button, A
critical display parameters such as size, position, pixel tracking, etc., based on the type of incoming source. An
Auto Setup can save considerable setup time, and you can still adjust the image as described below.
The best auto setup will be obtained under the following conditions:
• Input levels, it is best to have an image with saturated (very Bright) colors.
• Phase, high contrast edges are needed.
To determine active window size:
• Video images should have whites and blacks in the image
• Wide range video images should have content (including white) that extends to all edges of the image.
3.6

Size and Position Menu

Increase or decrease the size of your image, change its
proportion (aspect ratio), move the image to a specific
area of the screen, and refine other related parameters.
Use Size and Position controls to match the image
precisely to the screen used at the site.
Refer to if you need help using any of the options and
controls. Changes made in the Size and Position menu
are applied immediately and are saved when you exit
the menu (press E
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
2), both of which appear in the Main menu. From either of these two
ENU
A K
OWN RROW
or M ).
XIT ENU
will return to the previous menu (or to the presentation, if from
XIT
to access the "contrast" slide bar immediately. Press E
ONTRAST
.
EY
F
IGURE
Section 3: Operation
. This optimizes
UTO
3-17 - S P
IZE AND OSITION
ENU
XIT
M
ENU
3-17