Christie M-Series User Manual page 32

Section 2: Installation and Setup
literature provided with your equipment before connecting.
Ethernet Communications
Refer to Section 3 Operation
the Serial Command document provided in the Dealer Section of the Christie Website, PN 020-100224-XX.
Connecting Multiple Projectors
To connect multiple projectors in a network with serial communication:
RS232 NETWORK:
1. Connect the controlling source to the RS232 IN connector of the first projector in the network.
2. Using another serial communication cable, connect one end to the RS232 OUT connector and the other
end to the RS232 IN connector of the next projector.
3. Continue this pattern of connection with all projectors in the network. NOTE: The last projector in the
network will only have a connection to the RS232 IN connector, see
2-22
Use the RS422 port only if your device had RS422 capability - always consult the
F
IGURE
for further information about setting up and using a projector connected via Ethernet, and
F
IGURE
2-20 - C RS422
ONNECTING
2-21 - RS232 N
ETWORK
Figure 2-21 - RS232 Network.
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)