Christie M-Series User Manual page 47

black). Close the shutter to block the displayed image while maintaining access to projector functions.
Opening the shutter restores the image. NOTES: 1) The LCD display shows the current state of the shutter. 2)
The shutter is open upon power-up.
Function Key
IF WITHIN A NUMERIC FIELD IN A MENU: Use F
IF WITHIN A TEXT FIELD: Press F
between capital and lower case letters. Press F
insert or delete a character. Press F
IF WITHIN A PRESENTATION: Press F
numbers to enable a specific color or colors in the display (see right). For
example,
data. Eliminating one or more colors can help with certain diagnostics and
setups, such as when accurately overlaying one image on top of another from
stacked projectors. NOTE: Color enabling can also be implemented from
numerous locations within the menu system.
Press F followed by H
UNC
Brightness Uniformity settings. This will disable the features without changing
the settings associated with them.
Projector
Press P to access a specific projector within a group of projectors or to confirm if the local projector is
ROJ
listening. The number in the "Enter Number" window indicates which projector is currently listening to
commands, and will match the projector number that has been defined in the Menu Preferences menu.
The P checkbox (read-only) shows whether or not the projector physically connected to a keypad is
ROJ
listening to commands from that keypad. A checkmark means that connected projector is listening; if there is
no checkmark, you are communicating with a different projector.
To control a specific projector with the keypad, press P
the projector you want to use. If you switch to a projector other than the one you are currently using, the
checkmark will disappear.
To broadcast to multiple projectors, press P
Keypad commands will then effect all projectors present. NOTE: There is no method of controlling a group of
projectors within the same wired configuration using the wired keypad exclusively, since there is only one
wired protocol available. NOTE: The projector's address can be set in the Configuration Menu>
Communications Submenu.
Enter
Press E to select a highlighted item, to toggle a checkbox, or to accept a parameter adjustment and return
NTER
to the previous menu or image.
Exit
Press E to return to the previous level, such as the previous menu. NOTE: E
XIT
within text editing boxes (including number editing of a slide bar value) or within pull-down lists. It acts as a
"cancel" in these cases.
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
followed by the U
UNC
UNC
followed by E
UNC
UNC
will display only red, and
to disable Keystone, Edge Blending and
ELP
ROJ
to enter a negative number.
UNC
A
P RROW
followed by the L
EFT
to delete all characters.
NTER
followed by two numeric
will display green
and then enter the three-digit number assigned to
ROJ
and then P again without entering a projector number.
ROJ
Section 3: Operation
or D
K A K
EY OWN RROW
or R
A K A
RROW EY IGHT
F 3-3 - F
IGURE
does not save changes
XIT
to convert
EY
to
K
RROW EY
K
UNCTION EY
3-7