Christie M-Series User Manual page 56

Section 3: Operation
CHANNEL EDIT — STEP 3
If desired, review and/or edit the following channel setups in the Channel Edit menu:
• NAME:
An alphanumeric label can be defined and/or changed here. Channel names can be up to 12 characters in
length. The default name is the horizontal and vertical sync frequencies.
• CHANNEL:
A two-digit channel number can be changed here. NOTES: 1) If you enter a channel number that already
exists, a dialog message appears indicating that this number is already in use–assign a different channel
number. 2) You can define up to 99 channels.
• SLOT:
1-4, corresponding to which slot in the projector's input panel the source is connected:
• INPUT:
1-6, corresponding to which input on the selected slot the source is connected to.
• IN MENU:
If checked (default, except for automatically defined channels with unchanged parameters), this defined
channel will then appear in the list available when C
accessed via C
HANNEL
channel list is an option that must be set in the Menu Preferences menu.
• AUTO SELECT:
If checked, (default), the projector can automatically locate this channel when an incoming input signal
matches. If not checked, the projector can locate the selected channel only when it is directly selected via
on the keypad—and a change in input signal will not result in a channel change.
C
HANNEL
• LOCKED:
If checked, all of the image settings for this channel are locked. If unchecked (default), all available image
settings can be adjusted as desired. You cannot use Auto Setup with a locked channel.
• PREVIOUS CHANNEL:
Select this option to see or change Channel Edit settings for the previous channel in the Channel Setup list.
3-16
Channel Edit: 01
Card Type
H-Frequency
V-Frequency
Interlaced
Sync Source
1. Name
2. Channel
3. Slot
4.
Input
5. In Menu
6. Auto Select
7. Locked
8. Previous Channel
9.
Next Channel
F 3-16 C
IGURE
on the keypad or via the Auto Source function. NOTE: On-screen display of the
Video Decoder Input Card
15.73 kHz-
59.94 Hz-
Yes
S-Video
15.73kHz- i59.94Hz-
1
1
1
E
HANNEL DIT
key is pressed. If unchecked, the channel must be
HANNEL
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)