Projector Status Leds - Christie M Series User Manual

Projector status LEDs

Identify the input LED state colors and meaning.
Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2, Power,
and Status. The LEDs display the colors as shown below.
Projector state
Hard boot
Standby mode
Warm-up (Powering on
from standby)
Normal operation
Cool-down
Error
Software upgrade in
progress
Lamp Regeneration in
progress
A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
• The Status LEDS are cycling green
• The LCD displays the warning Image Processor Upgrading
• The LED on the image processor card flashes green
• The web page shows a warning that the image processor card is upgrading
• When this occurs, the projector should not be AC power cycled and the image processor card
should not be removed
M Series User Guide
020-101948-02 Rev. 1 (08-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
LEDs LED state
All All LEDs amber—Please wait
Lamps 1 and 2 Off—Lamps are off
Power Amber—AC is present but projector is off or standby
Shutter Green—Shutter is open
Amber—Shutter is closed
All LEDs cycle green from left to right
Lamps 1 and 2 Amber—Lamp time has expired and lamp should be replace
Power Green—Projector is powered up and operating normally
Shutter Green—Shutter is open
Amber—Shutter is closed
All LEDs cycle from left to right
Lamp 1 and 2 Amber—Lamp time has expired and lamp should be replace
Flashing red—Lamp time has expired and lamp should be replace
Power Flashing red—Error has occurred. Details are displayed on the
status display.
All The pattern will alternate between Amber and Off
Lamp 1 and 2 Flashing Green—The lamp is being switched off for its
regeneration period to extend lamp life (typically 15 minutes every
24 hours)
Power Green—On
Amber—Standby
Shutter Green—Shutter is open
Monitoring and maintaining the projector
60