Removing The Server From A Cabinet; Starting Your Server - Gateway E-9525R User Manual

CHAPTER 2: Setting Up Your Server

Removing the server from a cabinet

Screws are required to support the front
of the server. You must support the server
while removing the front screws and
while sliding the server off the cabinet
rails. If the server is not supported,
damage to the server or injury may result.

Starting your server

When you connect peripheral devices to
the server, make sure that your server and
devices are turned off and the power
cords are unplugged.
18
To remove the server from a cabinet:
Warning
Remove the thumbscrews through the handles that hold the server in the
1
cabinet.
While supporting the server, slide the server out from the cabinet.
2
Before you start your server for the first time:
Make sure that the server and monitor are plugged into a power outlet
■
or surge protector and that the surge protector (if you are using one) is
turned on.
Make sure that all cables are connected securely to the correct ports and
Caution
■
jacks on the back of the server.
To start the server:
Turn on any peripheral devices connected to the server.
1
Press the power button (1). The Power LED (2) lights.
2
www.gateway.com