Debug Vqpc - Cisco Catalyst 3750 Command Reference Manual

debug vqpc

debug vqpc
Use the debug vqpc privileged EXEC command to enable debugging of the VLAN Query Protocol
(VQP) client. Use the no form of this command to disable debugging.
Syntax Description
all
cli
events
learn
packet
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug vqpc command is the same as the no debug vqpc command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Catalyst 3750 Switch Command Reference
B-96
debug vqpc [all | cli | events | learn | packet]
no debug vqpc [all | cli | events | learn | packet]
(Optional) Display all VQP client debug messages.
(Optional) Display the VQP client command-line interface (CLI) debug
messages.
(Optional) Display VQP client event debug messages.
(Optional) Display VQP client address learning debug messages.
(Optional) Display VQP client packet information debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Catalyst 3750 Switch Debug Commands
78-16181-03