Cisco Catalyst 3750 Command Reference Manual page 508

Hide thumbs Also See for Catalyst 3750:

Table of Contents

This is an example of output from the show vlan internal usage command. It shows that VLANs 1025

and 1026 are being used as internal VLANs for Fast Ethernet routed ports 23 and 24 on stack member 1.

If you want to use one of these VLAN IDs, you must first shut down the routed port, which releases the

internal VLAN, and then create the extended-range VLAN. When you start up the routed port, another

internal VLAN number is assigned to it.

Switch> show vlan internal usage

---- -------------

1025 FastEthernet1/0/23

1026 FastEthernet1/0/24

Related Commands

private-vlan

switchport mode

vlan (global

configuration)

configuration)

Catalyst 3750 Switch Command Reference

Configures a VLAN as a community, isolated, or primary VLAN or

associates a primary VLAN with secondary VLANs.

Configures the VLAN membership mode of a port.

Enables VLAN configuration mode where you can configure VLANs 1 to

Configures VLAN characteristics in the VLAN database. Only available for

normal-range VLANs (VLAN IDs 1 to 1005). Do not enter leading zeros.

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands