Cisco Catalyst 3750 Command Reference Manual page 742

debug platform ip multicast
Usage Guidelines
The undebug platform ip multicast command is the same as the no debug platform ip multicast
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Catalyst 3750 Switch Command Reference
B-44
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Catalyst 3750 Switch Debug Commands
78-16181-03