Debug Platform Supervisor-Asic - Cisco Catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug platform supervisor-asic

Use the debug platform supervisor-asic privileged EXEC command to enable debugging of the
supervisor application-specific integrated circuit (ASIC). Use the no form of this command to disable
debugging.
Syntax Description
all
errors
receive
send
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug platform supervisor-asic command is the same as the no debug platform
supervisor-asic command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
78-16181-03
debug platform supervisor-asic {all | errors | receive | send}
no debug platform supervisor-asic {all | errors | receive | send}
Display all supervisor-ASIC event debug messages.
Display the supervisor-ASIC error debug messages.
Display the supervisor-ASIC receive debug messages.
Display the supervisor-ASIC send debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
debug platform supervisor-asic
Catalyst 3750 Switch Command Reference
B-65