Cisco Catalyst 3750 Command Reference Manual page 780

debug spanning-tree mstp
Usage Guidelines
The undebug spanning-tree mstp command is the same as the no debug spanning-tree mstp
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
show spanning-tree
Catalyst 3750 Switch Command Reference
B-82
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Displays spanning-tree state information.
Appendix B Catalyst 3750 Switch Debug Commands
78-16181-03