Debug Matm - Cisco Catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug matm

Use the debug matm privileged EXEC command to enable debugging of platform-independent MAC
address management. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines
The undebug matm command is the same as the no debug matm command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
debug platform matm
show debugging
78-16181-03
debug matm
no debug matm
Modification
This command was introduced.
Description
Displays information about platform-dependent MAC address management.
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Catalyst 3750 Switch Command Reference
debug matm
B-21