Cisco Catalyst 3750 Command Reference Manual page 316

service-policy
Examples
This example shows how to apply plcmap1 to an physical ingress port:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# service-policy input plcmap1
This example shows how to remove plcmap2 from a physical port:
Switch(config)# interface gigabitethernet2/0/2
Switch(config-if)# no service-policy input plcmap2
This example shows how to apply plcmap1 to an ingress SVI when VLAN-based QoS is enabled:
Switch(config)# interface vlan 10
Switch(config-if)# service-policy input plcmap1
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command
policy-map
show policy-map
show running-config
Catalyst 3750 Switch Command Reference
2-288
Description
Creates or modifies a policy map that can be attached to multiple ports to
specify a service policy.
Displays QoS policy maps.
Displays the running configuration on the switch. For syntax information,
select Cisco IOS Configuration Fundamentals Command Reference,
Release 12.2 > File Management Commands > Configuration File
Management Commands.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
78-16181-03