Cisco Catalyst 3750 Command Reference Manual page 370

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show env
On a Catalyst 3750G-48PS or 3750G-24PS switch, you can also use the show env temperature
command to display the switch temperature status. The command output shows the green and yellow
states as OK and the red state as FAULTY. If you enter the show env all command on this switch, the
command output is the same as the show env temperature status command output.
For more information about the threshold levels, see the software configuration guide for this release.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show env all command entered from the master switch or a
standalone switch:
Switch> show env all
FAN is OK
TEMPERATURE is OK
POWER is OK
RPS is AVAILABLE
This is an example of output from the show env fan command:
Switch> show env fan
FAN is OK
Configuring:
Switch(config)# system env temperature threshold yellow ?
<35-89> Temperature value in Degree Celsius
This is an example of output from the show env stack command:
Switch> show env stack
SWITCH: 1
FAN is OK
TEMPERATURE is OK
POWER is OK
RPS is NOT PRESENT
SWITCH: 2
FAN is OK
TEMPERATURE is OK
POWER is OK
RPS is NOT PRESENT
SWITCH: 3
FAN is OK
TEMPERATURE is OK
POWER is OK
RPS is NOT PRESENT
SWITCH: 4
FAN is OK
TEMPERATURE is OK
POWER is OK
RPS is NOT PRESENT
SWITCH: 5
FAN is OK
TEMPERATURE is OK
POWER is OK
RPS is NOT PRESENT
SWITCH: 6
FAN is OK
TEMPERATURE is OK
POWER is OK
RPS is NOT PRESENT
Catalyst 3750 Switch Command Reference
2-342
78-16181-03