Cisco Catalyst 3750 Command Reference Manual page 314

Hide thumbs Also See for Catalyst 3750:

Table of Contents

service password-recovery

If you use the no service password-recovery command to control end user access to passwords, we

recommend that you save a copy of the config file in a location away from the switch in case the end user

uses the password recovery procedure and sets the system back to default values. Do not keep a backup

copy of the config file on the switch.

If the switch is operating in VTP transparent mode, we recommend that you also save a copy of the

vlan.dat file in a location away from the switch.

When you enter the service password-recovery or no service password-recovery command on the

stack master, it is propagated throughout the stack and applied to all switches in the stack.

You can verify if password recovery is enabled or disabled by entering the show version privileged

EXEC command.

This example shows how to disable password recovery on a switch or switch stack so that a user can only

reset a password by agreeing to return to the default configuration.

Switch(config)# no service-password recovery

Switch(config)# exit

Related Commands

show version

Catalyst 3750 Switch Command Reference

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

Displays version information for the hardware and firmware.