Cold Booting The Cn2 - Intermec CN2 User Manual

Wa
Boo
but
The screen goes blank immediately. The screen remains blank
for a few seconds, the Refreshing the File System dialog box
appears, and the CN2 warm boots.
To warm boot the CN2 using the Power key
1 Press and hold the Power key for approximately 10 seconds.
Note: After about 5 seconds, the backlight toggles. Keep
holding the Power key for another 5 seconds until the
backlight flashes.
2 Release the Power key. The screen remains blank for a few
seconds, the Refreshing the File System dialog box appears,
and the CN2 warm boots.

Cold Booting the CN2

If the CN2 or application is locked up and does not respond to a
warm boot, follow this procedure to perform a cold boot. When
you perform a cold boot, all data in your RAM storage is
deleted.
To cold boot the CN2
1 Open the battery door and remove the battery. For help, see
"Removing the Battery" on page 8.
CN2 Handheld Computer User's Manual
Chapter 5 — Troubleshooting and Maintaining the CN2
95