Configuring 802.11B/G Radio Communications - Intermec CN2 User Manual

To use USB communications with your CN2
1 Connect the communications dock to the USB port of the
other device using an appropriate USB cable.
2 Make sure that your USB device is configured for USB
communications.
3 Insert the CN2 into the communications dock.
4 Turn on the CN2.
For more information about the communications dock, see the
instructions that ship with the communications dock.

Configuring 802.11b/g Radio Communications

Make sure all components with antennas are at least 30 cm
(1 ft) apart when power is applied. Failure to comply could
result in equipment damage.
Attention: Assurez-vous que la distance entre tous les
éléments avec antennes soit d'au moins 30 centimètres (un
pied) avant de faire la connexion avec l'alimentation
électrique, faute de quoi vous risquez d'endommager votre
installation.
The wireless CN2 has an internal 802.11b/g radio to transfer
data using wireless communications. This section of the manual
assumes that you have already set up your wireless
communications network including your access points. If you
are using a UDP Plus network, you also need to have your
Intermec Application Server communicating with a host
computer.
Your CN2 supports these network protocols:
• TCP/IP
• UDP Plus
The next sections explain the parameters you need to configure
for the CN2 to work in your wireless network.
CN2 Handheld Computer User's Manual
Chapter 3 — Adding the CN2 to the Network
39