Resetting The Ck61; Warm Booting The Ck61; Cold Booting The Ck61 - Intermec CK61 User Manual

Chapter 4 — Troubleshooting and Maintaining the CK61

Resetting the CK61

Warm Booting the CK61

Cold Booting the CK61

84
You rarely need to reset the computer. If the computer does not
resume after pressing the Power button, or if the computer or an
application lock up, you may need to reset the CK61. The CK61 uses
the configuration currently saved in flash memory during the boot
process. There are three ways to reset the CK61:
Warm booting the CK61
•
• Cold booting the CK61
• Clean booting the CK61
You may need to perform a warm boot to correct conditions where an
application stops responding to the system.
To warm boot the computer
• Press and hold the Power button for 10 seconds.
The computer systematically shuts down, restarts, and goes through
the initialization process.
In some cases where the computer completely stops responding, it
may be necessary to perform a cold boot. Because cold booting may
result in data loss, only use this method if all other recovery methods
have failed.
Note: Cold booting the CK61 does not guarantee that cached disk
data will be saved, so transactional data may be lost during the reset.
All other data is preserved.
To cold boot your CK61
1 Press the Power button to suspend the CK61.
2 Remove the battery pack from the CK61.
3 Press the Reset button on the back of the CK61.
4 Insert the battery pack back into the CK61.
CK61 Mobile Computer User's Manual With Windows CE