Configuring The Cn2 For Microsoft Wireless Zero Configuration - Intermec CN2 User Manual

The Intermec Application Server translates UDP Plus packets on
the wireless network into TCP/IP packets on the wired network
and vice versa. The access point acts as a bridge to allow
communications between the wired network and the wireless
network.
To use wireless communications in a UDP Plus network
1 Configure these network parameters on each CN2 in the
network:
• Network name (SSID)
• Controller IP address
• IP settings (if not using DHCP)
• Controller port (set to 5555)
2 Configure the security. For help, see "Configuring Network
Security" on page 45.
The easiest way to configure the network parameters on the
CN2 is to use Intermec Settings. For help, see "Configuring the
CN2 Locally With Intermec Settings" on page 32.

Configuring the CN2 for Microsoft Wireless Zero Configuration

You can use Microsoft Wireless Zero Configuration with your
wireless CN2. Wireless Zero Configuration gives you a
convenient way to view wireless network parameters and a list of
available wireless networks.
To use Wireless Zero Configuration on your CN2
1 Tap Start > Intermec Settings > Communications > 802.11
Radio > Security Settings and make sure that Security
Choice is set to Microsoft Security.
If Security Choice is set to Funk Security, select Microsoft
Security, save your settings, and warm boot the CN2. For
help, see "Warm Booting the CN2" on page 94.
Note: You must warm boot the CN2 after you change your
security choice.
CN2 Handheld Computer User's Manual
Chapter 3 — Adding the CN2 to the Network
43