Configuring Static Wep Security With Funk Security; Configuring Static Wep Security With Microsoft Security - Intermec CN2 User Manual

Chapter 3 — Adding the CN2 to the Network
To use WEP security, you need:
• an access point with an 802.11b/g radio.
• a CN2 handheld computer with an 802.11b/g radio.

Configuring Static WEP Security With Funk Security

1 Make sure you have configured the communications and
radio parameters on your CN2.
2 Make sure you have chose Funk Security software as your
security choice, as described in "Choosing Between Microsoft
Security and Funk Security Software" on page 45.
3 Open Intermec Settings.
4 Tap Communications > 802.11 Radio > Security Settings
> Funk Security > Profile.
5 For Association, choose Open, and then tap Save.
6 For Encryption, choose WEP and then tap Save.
7 For Authentication, choose None and then tap Save.
8 Select WEP Key and then define a value for each WEP key.
You can define up to four WEP keys.
Enter an ASCII key or a hex key that is either 5 bytes or 13
bytes long depending on the type of WEP encryption you are
using. Set a 5-byte value for 64-bit WEP or a 13-byte value
for 128-bit WEP. Hex values must be preceded by 0x and
contain 5 or 13 hex pairs.
9 Select Network Key Index, choose the WEP key you want to
use for transmitting data.
10 Exit Intermec Settings.

Configuring Static WEP Security With Microsoft Security

1 Make sure you have configured the communications and
radio parameters on your CN2.
2 Make sure you have selected Microsoft as your security
choice, as described in "Choosing Between Microsoft Security
and Funk Security Software" on page 45.
3 Open Intermec Settings.
58 CN2 Handheld Computer User's Manual