2-176
Features and Operation
Hold - Exclusive
Description
When a line is placed on Exclusive Hold, no other station in the system can retrieve the call.
Operation
Exclusive Hold may be programmed and activated on the first or second depression of the
HOLD button. CO Lines, while in a transfer hold, are always placed in an Exclusive Hold
condition.
SINGLE LINE TELEPHONE
While connected to an outside line, to place a call on Exclusive Hold:
Press the FLASH button. Handset must stay off-hook.
To retrieve the call:
Press the FLASH button again.
Exclusive Hold Flash Rate
Description
The Exclusive Hold flash rate is the rate at which a CO Line button or Loop button flashes
when a call is placed on Exclusive Hold. This flash rate can be programmed to 29 different
options identified in the flash rate table. This enables the programmer to customize the key
system configuration to desired flash rates.
Programming Steps
1. Press the EXCLUSIVE HOLD flexible button (FLASH 07, Button #12). The following
message displays:
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options (refer to
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... Exclusive Hold flash rate is set for a Green 120 ipm Flash (24).
STARPLUS STSe - Programming & Operations Manual
E XC LU S IV E HOL D
G R EE N 1 2 0 I P M F L AS H
Table 2-16 on page
2-163).
00-28
Hold - Exclusive
August 2005