2-236
Features and Operation
Programming Steps
1. Press FLASH and dial [22]. The following message displays:
2. Press the AUTO/MANUAL flexible button (FLASH 22, Button #1). This feature toggles on
and off each time the button is pressed. The display updates with each toggle.
LED On = Automatic Night Mode
LED Off = Manual operation
3. If no other changes must be made, press HOLD to save the entry. A confirmation tone
sounds.
Day of Week Programming
Programming Steps
The MONDAY flexible button (Button #2) LED is lit. To change days of the week:
1. Press the appropriate DAY OF WEEK flexible button (FLASH 22, Buttons 2-8).
2. Enter a valid number to indicate the hour and minutes to end night mode.
3. Press HOLD to save the entry. (Example: 07301830 [HOLD]) A confirmation tone sounds
and the display updates.
Automatic Night Mode Operation
The STSe can be programmed in database administration to place the system into Automatic
Night Mode. The Attendant(s) can override the Automatic Night Mode schedule simply by
pressing the NIGHT (DND) button [631].
External Night Ringing
The system can be programmed so that CO lines marked for UNA rings on the external page
speakers. Refer to
Manual Operation
The Attendant(s) can control the use of Night Mode manually by pressing the NIGHT (DND)
button [631]. An LED indicates when the system is in Night Mode operation (flashing =
Special Mode, off = Day Mode).
Night Class of Service (COS)
The system allows each station to be assigned a different COS for night operation. The night
COS goes into effect when the system is put into night mode manually or via the automatic
schedule. Prevents the misuse of phones after hours.
STARPLUS STSe - Programming & Operations Manual
D AY
E ND
S TAR T AUTO
M O N
0 80 0
1 7 0 0
Once enabled, this feature addresses the entire week.
"Universal Day/Night Answer" on page
N O
2-329.
Night Service
August 2005