2-124
Features and Operation
DID Incoming Signaling
Description
The DID Incoming Signal option allows the installer to determine the type of incoming
signaling used by all T-1 trunks in the system.
Programming Steps
DTMF is the DID Signaling type used for DID Trunks. Do not change the default setting of
DTMF unless instructed to do so by technical support.
1. Press the DID INCOMING SIGNALING flexible button (FLASH 41, Button #5) for
programming the type of DID signaling desired.
The following message is shown on the display phone:
2. Enter a 0 or 1 on the dial pad.
[0] = Not applicable (reserved for future use)
[1] = DTMF
3. Press the HOLD button to save the entry. A confirmation tone sounds and the display
updates.
DEFAULT ... DID Incoming Signaling type is set for DTMF.
DID/TIE Signaling
Description
The DID/TIE Signaling feature can be programmed for one-way direct access inward dialing
access to specific stations on specific DID lines without going through an Attendant
answering position.
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
STARPLUS STSe - Programming & Operations Manual
D I D I N C S I GN A LI N G
D T M F
CO L I N E AT T R I B U T E S
S E L EC T A CO L I NE R A NG E
If HOLD is pressed without entering a CO line range, all CO lines are selected.
Direct Inward Dialing
0-1
August 2005