Database Printout (Dump)
Database Printout (Dump)
Description
Through a system programming command, either portions of or a complete database dump
can be printed using one of the RS-232C connectors located on the BKSU.
The Print System Database command dumps the entire database as a permanent record
which can serve as a hardcopy of the database. The system baud rate must match that of the
printer or receiving device.
Printing the entire database takes a while to print. A database prints in the following order:
1. All System Parameters
2. All CO Line Programming
3. All CO Ports
4. All Station Attributes
5. All Station Ports
6. Exception Tables (Allow/Deny/Special)
7. System Speed Dial Numbers
8. ICLID Ringing Assignment Table
9. Directory Dialing Table
10. Hunt Group Parameters (Bins
11. LCR Tables
12. ICLID Parameters and Table(s)
13. UCD Group Parameters
14. Voice Mail Group Parameters
15. DID Translation Table
16. DID-TIE Timers
17. Verified Account Codes Table
Programming Steps
1. Press the ENTIRE SYSTEM flexible button (FLASH 85, Button #8). The following message
displays:
2. To print the entire database, press the HOLD button. The display updates to indicate what
portion of the database is printing.
3. When the system finishes sending the database to the printer, a confirmation tone
sounds.
STARPLUS STSe - Programming & Operations Manual
9020-9099
)
P R I NT D ATA B AS E
P R ES S HOL D
2-109
Features and Operation
August 2005