Vodavi STARPLUS STSe Operation Manual page 80

2-56
Features and Operation
Related Information
Flash 80
Programming Steps
1. Press FLASH and dial [24]. The following message displays on the display:
2. Press the button corresponding to the desired SLOT location. (Buttons #1-14 indicate
peripheral card slots 0-13.)
3. Enter a valid number for the type of card plugged into the current peripheral card slot.
[00] = None
[02] = DTIB
[04] = SL02 (represents SLIB w/ 2 ports) [16] = SI04 (represents SLIBC w/ 4 ports)
[08] = PRIB
[09] = T1IB
4. If the T1IB option is selected in step 3, then enter a valid number (1-5) to specify the
desired cluster (partial) quantity; otherwise, skip to step 5.
[1] = cluster of 4
[2] = cluster of 8
[3] = cluster of 12
5. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
6. Press the reset button on the Main Board Unit (MBU).
DEFAULT ... Slot 0, 1, and 2 are identified as DTIB, LCI4, and SL02 respectively.
Conditions
»
After programming card slots, a system reset must be performed.
»
If a caller ID card is used in the system, you must use FLASH 40, Page C, Button #2 to set
the Ring Delay Timer to a setting of 05 (sec). This allows sufficient time for receipt of ICLID
information from the telephone company. Refer to
STARPLUS STSe - Programming & Operations Manual
Quick Reference
Button #20 System Reset (refer to
C A BI NE T 0
E N TE R B UT TON NUMB ER
C A B 0 SLOT XX
D T IB
[4] = cluster of 16
[5] = cluster of 20
No Entry = All CO lines
"System Reset" on page 2-298
00-21
[13] = SL04 (represents SLIB w/ 4 ports)
[15] = LCI4 (represents LCOBC)
[17] = VM1B (represents VM Interface Board)
"Ring Delay Timer" on page
Card Slot Programming
).
A-9.
August 2005