ICLID Programming
3. After all entries are made, press HOLD to accept the data.
Enable/Disable
Description
The ICLID (Incoming Calling Line IDentification) feature was added to the STSe system. For this
feature to operate properly, it must be activated from the Central Office so the numbers of
the calling party are delivered over the individual tip and ring of the CO lines between the
first and second ring cycle.
Programming Steps
1. Press the DISABLE/ENABLE flexible button (FLASH 56, Button #1) to toggle between the
options of NO for disable and YES for enable.
2. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT ... ICLID is disabled (NO option).
Name in Display
Description
The system can be set to display the incoming telephone number or the person's name on
the LCD display.
Programming Steps
1. Press the NAME flexible button (FLASH 56, Button #2) to toggle between the options of
YES to show the name or NO to show the incoming telephone number in the LCD.
2. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT ... The system shows the name on the LCD display (YES option).
STARPLUS STSe - Programming & Operations Manual
If caller ID is used in the system, you must use Flash 40, Page C, Button #2 to set the
Ring Delay Timer to a setting of 05 (sec). This allows sufficient time for receipt of
ICLID information from the telephone company (refer to
page A-9
).
A-7
ICLID / Caller ID
"Ring Delay Timer" on
August 2005