Parameters Description - D-Link xStack DES-3526DC User Manual

xStack DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
The user may search for the settings of a particular Access ID by entering that ID into the Access ID field above and clicking Find.
The user may display all Access ID entries by clicking the View All Entry button.
To remove a previously created rule, select it and click the
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters
Profile ID
Mode
Access ID (1-65535)
Type
Figure 6- 64. Access Rule Table window (Ethernet)
Figure 6- 65. Access Rule Configuration window (Ethernet)
Description
This is the identifier number for this profile set.
Select Permit to specify that the Switch, according to any additional rule, forwards the
packets that match the access profile added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 - 65535.
Auto Assign – Checking this field will instruct the Switch to automatically assign an Access
ID for the rule being created.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content Mask.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header
•
button. To add a new Access Rule, click the Add button:
87