Card Shot - Sharp MX-M700U Operation Manual

Card shot

When copying a card, this function allows you to combine the front and back sides on a single sheet of paper.
Original
CARD
CARD
Front of
card
Back of
card
Example:
Portrait
A4 (8-1/2") size
1 Touch the [PAPER SELECT] key and then
select the desired paper size.
READY TO SCAN FOR COPY.
1. A4 2. B5
A4
PLAIN PLAIN PLAIN
5. A4
3. A4 HEAVY PAPER
4. A3 PLAIN PLAIN
NOTE
If paper of the desired size is not loaded in any tray,
load paper of the required size in a paper tray or the
bypass tray. (See "Setting the paper type and paper
size" on page 2-14.)
To display the special modes screen...
See "General procedure for using special
functions" on page 5-2.
2 Touch the [CARD SHOT] key in the special
modes screen (2nd screen).
TRANSPARENCY
MULTI SHOT
INSERTS
TAB COPY

CARD SHOT

Copy
CARD
Example:
Landscape
A4 (8-1/2") size
The selected paper size
key is highlighted and
the paper selection
screen closes.
The CARD SHOT
setting screen will
appear. A card shot
icon ( , etc.) will also
appear in the upper left
corner of the screen to
indicate that the
function is turned on.
● Copying is only possible on standard size paper.
● A copy ratio cannot be selected when using this
function.
● The image cannot be rotated when using this
function.
3 Enter the X dimension (width) and Y
dimension (length) of the original with the
keys.
CANCEL OK
SIZE RESET
FIT TO
PAGE
●X (width) is initially selected. Enter X and then
touch the Y ( ) key to enter Y.
●To return the X and Y values to the initial
settings configured in the administrator
settings, touch the [SIZE RESET] key. (See
"CARD SHOT SETTINGS" on page 16 of the
administrator settings guide.)
●To have the images enlarged or reduced by a
suitable ratio based on the entered original
size so that the front and back sides fit into the
selected paper size, touch the [FIT TO PAGE]
key.
SPECIAL MODES
5
5-29