Sharp MX-M700U Operation Manual page 39

■ Loading paper in the AR-LC7
If the paper runs out during printing, a message will appear in the display. Follow the procedure below to load
paper.
1 Pull the tray out until it stops.
NOTE
To add or change paper, press the operation button.
the tray out when the indicator is blinking or solidly lit
may damage the tray.
2 Place the paper on the paper table.
Indicator
line
approximately 500 sheets of A4 size (8-1/2" x 11")
80 g/m
2 (20 lbs.) paper can be placed. After the
paper is placed, the paper table will descend to a
position where an additional approximately 500
sheets can be placed. When the paper table has
descended all the way, approximately 3000 sheets
can be held.
If a different type of paper is loaded that was used
previously, the paper settings for tray 5 must be
changed on the machine. Be sure to change to the
appropriate settings as explained in "Setting the
paper type and paper size" on page 2-14.
Pull the finger grip up
and pull the tray out
until it stops.
When the button is
pressed, the indicator
will blink until the paper
table stops descending.
Do not pull the tray out
until the indicator turns
off. Attempting to pull
The paper stack must
not be higher than the
indicator line.
When the paper tray is
pulled out, the paper
table will have
descended to a
position where
CAUTION
When loading paper, take care not to insert your
hands into holes on paper table.
Do not insert your
hands here.
NOTES
● Use SHARP-recommended paper (page 2-22).
Special paper cannot be used.
Push the tray firmly all the way into the
3
machine.
LOADING PAPER
Do not insert objects in
the tray or attempt to
place spare paper in
the tray. This may
damage the tray.
After the tray is pushed
in, the indicator will
blink until the paper
table finishes
ascending and then
light solidly.
2-9
2