Placing Originals - Sharp MX-M700U Operation Manual

PLACING ORIGINALS

■ Using
the automatic
feeder
1 Open the document cover, make sure that
an original has not been left on the
document glass, and then gently close the
document cover.
2 Adjust the original guides to the size of the
originals.
3 Place the originals face up in the
document feeder tray.
line (maximum of 150 pages).
NOTE
Original size detection function
One of the four groups of standard original sizes shown below can be selected for detection by the original size
detection function. The factory default setting is "AB-2". The setting can be changed using "ORIGINAL SIZE
DETECTOR SETTING" in the administrator settings.
Group
1 AB-1
2 AB-2
3 INCH-1
4 INCH-2
document
Place the originals face
up.
Insert the originals all
the way into the
document feeder. The
stack height must not be
higher than the indicator
Detectable original sizes
Document feeder tray (for reversing automatic document feeding)
Document glass
A3, A4, A4R, A5,B4, B5, B5R
A3, A4, A4R, A5,B5, B5R, 216x330
11" x 17", 8-1/2" x 14", 8-1/2" x 11",
8-1/2" x 11"R, 5-1/2" x 8-1/2"
11" x 17", 8-1/2" x 13", 8-1/2" x 11",
8-1/2" x 11"R, 5-1/2" x 8-1/2"
■ Using the document glass
Open the document cover, place the
original face down on the document glass,
and then gently close the document cover.
NOTES
● After placing the original, be sure to close the
document cover. If left open, parts outside of the
original will be copied black, causing excessive
use of toner.
● Do not place any objects under the original size
detector, because they may damage it or the
original size may not be detected properly.
Document glass scale
mark
B4 or
B5 8½x14
A4 or 8½x11 A3 or 11x17
●Align the corner of the original with the tip of the
arrow mark on the document glass scale.
●Place the original in the appropriate position for its
size as shown above.
Document glass + 8-1/2" x 11", 216x330
Document glass + 8-1/2" x 11", B4
Document glass + A4
Document glass + A4
Document glass scale
mark
B5
A4 or 8½x11
4-3
4